AMX APEX Destiny 6100 Dokumentacja Pobierz pdf (Strona 74)

Control Channel Terms

Automated Control Channel Locations

Set On/Off: This location is used to program automatic on and off times for control channels. Enter

9992, the system will respond "ENTER UNIT." Enter a control channel number, if the

channel is 1-9 use a leading zero. The next prompt is "ENTER ON." Enter the on time

in 24hr format. The next prompt is "ENTER OFF." Enter the off time in 24hr format.

The on and/or off times are only used by the system if they are enabled in "Remote

Control Options 1." Both times must be programmed even if only one time is being

used. If both on and off times are the same value, the unit will never turn off.

Control Channel Options 1:

Enable seconds: If the "automatic turn off" feature is being used, this option determines if the time

"on units" should be treated as minutes or seconds.

Restart delay activation: When a zone is used to trigger a remote channel, this option determines if the

countdown restarts each time the zone is activated. If a light is dependant on a motion

detector, this option would be enabled to keep the light from turning off then on again

each time motion is detected.

Automatic turn off: This option is used to turn a channel off after the time "on units" time expires. The

"enable seconds" option determines if the units are treated as seconds or minutes.

Enable Dim: The option enables the dim command to be used from Remote Control Mode. If the

X-10 receiving device does not support dimming the command will be ignored.

On/Off Time of Day: Used to automatically turn a channel on or off based on time of day. Location 9992 is

used to set the on and off times.

Control Channel Options 2:

Day of week operation: Add the value for each day automatic on/off should occur. For every day of the week

use 127, for only weekdays use 62.

Control Channel Options 3:

Activate Chain Channel: All Channels can be programmed to control an X-10 device or trigger a group of

activations (see Automation Overview).

Sunrise/Sunset Options: Each channel can be programmed to turn on or off at sunrise or sunset. Enter the total

for the appropriate options in the Control Channel Options 3 location for the channel.

Note: A light sensing device must be attached to the system either as a zone input or as

an X-10 input (X-10 Sundowner) for the sunrise/sunset option to function.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 83 84

Brak uwag

AMX APEX Destiny 6100 Dokumentacja Strona 74