AMX APEX Destiny 6100 Dokumentacja Pobierz pdf (Strona 63)

Arm to HOME: Arm the system to HOME, all open zones are force armed.

Sunrise: Available on all button devices but primarily used with an X-10 Sundowner. When

using X-10 as an input, this button function tells the system that it is currently daytime.

Control channels can be programmed to activate or restore based on sunrise/sunset.

Sunset: Same as Sunrise but tells the system it is currently dark.

Disarm: Disarm the system

Remote System Mode: Places the system in a mode intended for sending keypress information to other systems

through the RS-232 port. 'H' or '#' exits.

Output Control: See "Control Channel" section.

Keypad Functions

Keypad Number: The system supports addressable and non-addressable keypads. When addressable

keypads are used, each keypad may have custom key combination configurations, a

specific zone number, and custom speech descriptions during activations. Those

keypads that are not addressable share keypad address number 1. Note, if keypads are

not assigned to a zone they are assigned to zone 96 by default.

Note: At time of printing, all LED keypads are non addressable (RK36). The RKLCD

keypad is not addressable and is NOT compatible with this system. The RKLCD keypad

is addressable and is designed for this system. Press the 1 and F2 keys simultaneously,

the display will show "Keypad Numb = 1." Pressing 1 and F2 will advance to the next

keypad number. Although the keypad's address can be advanced to 9 - 16, the system

will only support 1 - 8. To clear the display, press status.

Key Combinations: The chart is used for setting custom key combinations. Non addressable keypads and

addressable keypad number 1 share the same locations. To change a key combination,

select the column for the keypad and the desired key or combination. Enter the Key

function in the location. Note, these key combination changes will not take effect until

a zone is assigned to the selected keypad.

TS16 display: Temperatures from TS16's can be displayed on individual keypads. TS16s 1-8 are

entered into the group 1 location. TS16s 9-16 are entered into the group 2 location.

Add the value for each TS16 to be displayed and enter the total in the appropriate

location. It may take up to 10 minutes to display the temperature. To speed up the

process, turn the panel off then on.

Area: A keypad can be programmed to display information for specific areas when split

arming is enabled. Enter the total of the values pertaining to areas for the keypad to

display in the "area" location.

User Code + Functions

Codes 1 - 5: These codes can be assigned to any of the "Key Functions." There are separate locations

for local phone / keypads and remote phone.

Smoke Reset: Enter a full function user code followed by the 6 digit to reset hardwire smoke detectors.

Power to the smoke detectors is momentarily interrupted allowing them to reset. The

system will speak, "SMOKE POWER" and activate the assigned smoke power trigger

output.

Change User Codes: See "User Codes" section

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 83 84

Brak uwag

AMX APEX Destiny 6100 Dokumentacja Strona 63