AMX MAX-HT12T Instrukcja Obsługi Pobierz pdf (Strona 45)

MXT/D-700 - 7" X Series Panels

MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels

Removing the MXD-700

The MXD-700 is held in place to the Backbox via latch hooks and clips on the Backbox, securing it to the mounting

surface. In certain circumstances, such as firmware updates or other maintenance that requires accessing the device’s

USB port, the device may need to be removed from the Backbox.

The clips that lock down the MXD-700’s bottom edge (Landscape) or right edge (Portrait) may be unlatched in order to

remove the device from the mounting surface.

Removing an MXD-700 from Its Backbox

1. The MXD-700 has three rows of ventilation holes along the molding (FIG. 38):

2. On the bottom (Landscape) or right side (Portrait) of the MXD-700, locate the fifth ventilation holes from each

edge, on the row closest to the Backbox (FIG. 39): .

3. With a stout, strong point (a push pin or straightened paper-clip, for example), carefully press into the access holes

in either end of the molding until the snap is disconnected.

To facilitate the disconnection, grasp the bottom of the panel (Landscape) or right side (Portrait) and pull gently

outward until the side of the panel is free of the snap. Use your other hand to hold stable the front of the touch panel.

FIG. 38 MXD-700 Molding (highlighted in blue)

FIG. 39 Bottom View (Landscape) or Right-Side View (Portrait) of the MXD-700 showing access holes in molding

Molding Molding

Access hole Access hole

Panel (surface)

#5 #5

Always pull on the frame of the touch panel. NEVER pull on the glass edge.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 61 62

Brak uwag

AMX MAX-HT12T Instrukcja Obsługi Strona 45