AMX MAX-HT12T Instrukcja Obsługi Pobierz pdf (Strona 15)

MXT/D-1000 - 10.1" X Series Panels

MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels

Power via PoE

Power for the MXT-1000 is supplied via PoE (Power Over Ethernet ), utilizing an AMX-certified, capacitive touch-

compliant PoE injector such as the PS-POE-AT High Power PoE Injector (FG423-81) or other approved AMX PoE

power source. The incoming Ethernet cable should be connected to the RJ45 port on the cable attached to the device.

Ethernet Cable Installation and Modification

In installations where concealing the Ethernet cable is desired, a hole at least 1.00” (2.54 cm) in diameter is required in

the surface to allow passage of the female RJ45 connector (FIG. 11).

If using a smaller hole is unavoidable, you will need to disconnect the Ethernet cable (ECA5968-05) from the device, to

feed the male end of the cable through.

To disconnect and reconnect the MXT-1000’s Ethernet cable to allow use of a hole smaller than 1.00” in diameter:

1. On a soft surface, turn the MXT-1000 face-down to access the bottom of the device.

2. Remove the clamp holding the Ethernet cable (FIG. 11).

3. Remove the Ethernet cable connector and pull the cable out of the clamp.

4. Pass the Ethernet cable (ECA5968-05) through the hole, with the RJ45 connector on the other side of the

installation surface from the device.

5. Press the Ethernet cable back into the clamp.

Do NOT tighten the clamp at this time.

6. Using a non-conductive item such as a wooden stick, reinsert the Ethernet cable connector into the device.

Ensure that the connector is properly seated.

7. Tighten the clamp to secure the Ethernet cable.

Make sure the clamp is around the bundled black cable, not the individual wires

8. Connect the RJ45 connector to its incoming Ethernet cable and apply power.

FIG. 11 Bottom of the MXT-1000

Ethernet Cable

Connector

Clamp

MXT-1000

The minimum diameter hole through which the Ethernet cable may pass is 0.50"

(1.27 cm).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Brak uwag

AMX MAX-HT12T Instrukcja Obsługi Strona 15