AMX NXB-CCG Dokumentacja Pobierz pdf (Strona 25)

Web Interface Pages

NXB-CCG NetLinx® Clear Connect™ Gateway

Entering Activation Mode

To enter Activation Mode:

1. In the Add Devices page, click the Add/Remove Devices button to enter the Add/Remove Devices Mode

(FIG. 20).

2. Wait while the NXB-CCG attempts to enter activation.

a. Entering activation may fail due to another system being in activation. This will open the Unable to

enter add/remove device mode popup window (FIG. 21).

b. Entering activation may fail due to house code collision. This condition is extremely unlikely, as

random house codes are picked when the device first enters activation and upon collisions with other

house codes.

3. The network is now waiting for devices to report themselves.

The devices that you wish to activate should have all their LEDs blinking slowly (two seconds on, one seconds

off). If the devices are not blinking, triple-tap-hold-triple tap them to restore them to their factory defaults, and

then wait a minute until they begin showing the activation mode feedback.

Adding Devices

Once in Activation Mode, new devices can be added to the system and currently activated devices can be

removed. To add new devices, do the following:

1. Press and hold the device to be added to the network, and verify that is exhibiting the appropriate LED

feedback on the appropriate button.

FIG. 20 Entering Add/Remove Devices Mode

FIG. 21 “Unable to enter/remove device mode” prompt

You may retry entering the Add/Remove Device mode when the other system is out

of that mode.

Sensors will not show activation feedback.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Brak uwag

AMX NXB-CCG Dokumentacja Strona 25