
Appendix B – Telnet (Terminal) Commands
115
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Telnet Commands (continued)
SHOW CONNECTION
STATS
Shows the connection statistics for the device.
Output similar to the following example:
>show connection stats
Connection Statistics
Total Last 15 Minutes
===== ===============
ICSP Messages: 10039 received 333 received
10038 transmitted 333 transmitted
Blink Messages: 5014 received 166 received
IP Statistics:
RX packets:29298 errors:0 discarded:0
TX packets:15286 errors:0 discarded:0
SHOW LOG Displays the message log.
Syntax:
SHOW LOG <start>
Specifies the message number to start displaying.
SHOW LOG <all> or SHOW LOG
Displays all messages.
SHOW VS100 STATS Displays DXLink transport information (MSE values, length, etc.).
WD Queries / enables / disables the Offline Recovery Mechanism (for complete information see
page 66).
Important: A reboot is required after setting the recovery mechanism before the new setting
takes effect.
Syntax:
WD
Queries the module for the setting of the Offline Recovery Mechanism.
WD ON
Sets the recovery mechanism to ON.
WD OFF
Sets the recovery mechanism to OFF (default).
Komentarze do niniejszej Instrukcji