AMX NXT-CV10 Dokumentacja Pobierz pdf (Strona 33)

CV10 Touch Panel Accessories

10" Modero Touch Panels

6. Locate the two screw holes at either sides of the front speaker grill and then use a grounded

Phillips-head screwdriver to remove the two Tilt Bracket Screws (FIG. 19). This procedure both loosens

the rear Tilt Bracket cover plate (with the AMX logo and Hinge brackets) and provides greater flexibility

for the removal of the outer housing. Without this step, the Hinge brackets (FIG. 19) present an obstacle

to the removal of the outer housing and restrict access to the circuit board.

7. Tilt the LCD panel back up to gain better access to the Tilt Bracket cover plate.

8. In a single motion, carefully pull both the Tilt Bracket cover plate and outer housing up and then out

(away from the LCD panel) to expose the internal circuit board (FIG. 20).

FIG. 19 Location of the Tilt Bracket screws

FIG. 20 Removal of the outer housing and wireless card location

Base

Outer Housing

Hinge Brackets (2)

Tilt Bracket Screws (2)

These two screws must

first be removed before

being able to remove

the outer housing.

Tilt Bracket/Speaker assembly

Outer housing

Tilt Bracket cover plate

Base

Outer Housing

installation holes

(located on front panel)

(must be removed first)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 207 208

Brak uwag

AMX NXT-CV10 Dokumentacja Strona 33