AMX NXI Dokumentacja Pobierz pdf (Strona 22)

Programming

NXI NetLinx Integrated Controller (No Master)

IR/Serial Send_Commands (Cont.)

CTOF Sets the duration of off time (no signal) between IR pulses for channel and IR function

transmissions. Off time settings are stored in non-volatile memory.

The factory default for channel off time is 5 (.5 second).

This command is associated with the SP (single pulse) and CP (clear pulse) commands.

Syntax:

SEND_COMMAND <DEV>,"'CTOF',<Time>"

Variable:

Time = 0-255 in tenths of a second increments

Example:

SEND_COMMAND IR_1,"'CTOF',10"

Sets the off time between each IR pulse to 1 second.

CTON Sets the total time of IR pulses transmitted, and is stored in non-volatile memory.

Syntax:

SEND_COMMAND <DEV>," 'CTON',<Time>"

Variable:

Time = 0-255 in tenths of a second increments; default = 5 (.5 second).

Example:

SEND_COMMAND IR_1,"'CTON',20"

Sets the IR pulse duration to 2 seconds.

GET MODE Polls the IR/Serial ports and reports the active mode settings to the device requesting the

information.

Syntax:

SEND_COMMAND <DEV>, 'GET MODE'

Example:

SEND_COMMAND IR_1,'GET MODE'

System response example:

PORT 4 IR,CARRIER,IO LINK 0

IROFF Halts and clears all IR output on the designated port.

Syntax:

SEND_COMMAND <DEV>,'IROFF'

Example:

SEND_COMMAND IR_1,'IROFF'

Immediately halts and clears all IR output signals on the IR_1 port.

POD Disables active PON (power on) or POF (power off) command settings.

Channel 255 changes are enabled. This command is used in conjunction with the I/O Link

command.

Syntax:

SEND_COMMAND <DEV>,'POD'

Example:

SEND_COMMAND IR_1,'POD'

Disables PON and POF command settings on the IR_1 device.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag

AMX NXI Dokumentacja Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kontrolery urządzeń peryferyjnych AMX NXI