AMX NI-3100 Dokumentacja Pobierz pdf (Strona 19)

Initial Configuration and Firmware Upgrade

NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)

10. Click Reboot (from the Tools > Reboot the Master Controller dialog) and wait for the System Master to

reboot and retain the newly obtained DHCP Address.

The STATUS and OUTPUT LEDs should begin to alternately blink during the incorporation. Wait until

the STATUS LED is the only LED to blink.

11. Press Done once until the Master Reboot Status field reads *Reboot of System Complete*.

12. Complete the communication process by continuing on to the Communicating Via an IP Address section

on page 10.

Assigning a Static IP to the NI Controller

1. In NetLinx Studio, select Diagnostics > Network Addresses from the Main menu to access the Network

Addresses dialog (FIG. 8).

2. Verify that both the System number corresponds to the System value previously assigned within the

Device Addressing tab and that zero (0) is entered into the Device field.

3. Click the Get IP Information button to temporarily configure the on-board Master for DHCP usage and

then read the IP Address obtained from the DHCP Server.

4. Click the Specify IP Address radio button from the IP Address section. With this action, all IP fields

become editable.

5. Verify that NetLinx appears in the Host Name field (if not, then enter it in at this time).

6. Enter the IP Address, Subnet Mask, and Gateway information into their respective fields.

7. Click the Set IP Information button to cause the on-board Master to retain this new IP Address (pre-

obtained from the System Administrator).

8. Click OK to accept the change to the new IP/DNS information.

Verify that these IP values are also entered into the related fields within either the



IP Settings section of the System Connection page (on the touch panel) or within the

Address field on the web browser.

Verify there is an active LAN connection on the LAN port of the Master before

beginning these procedures.

FIG. 8 Network Addresses dialog (for a pre-obtained Static IP Address)

System Address

reflects the value

set in the Device

Addressing tab

Used to retain an

IP Address

The system value must correspond to the Device Address previously entered in the

Device Addressing tab. Refer to the Manage System - System Number section on

page 39 for more detailed instructions on setting a system value.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 159 160

Brak uwag

AMX NI-3100 Dokumentacja Strona 19