AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Instrukcja Obsługi Pobierz pdf (Strona 10)

Installation

AXP-PLV PosiTrack Pilot Video Camera Controller

positions and their corresponding values. The device number takes effect only after powering-

up.

4. Once completed, rotate the unit and lay it on a flat surface. Refer to the Setting the Device

Base section on page 12 for more information on changing the touch panel device number.

Wiring the AXP-PLV

The AXP-PLV has an AXlink four-wire mini-XLR connector (located on the rear of the AXP-PLV)

and a BNC male connector (at the rear of the unit) A female mini-XLR cable (provided) is supplied

to facilitate wiring.

Wiring guidelines

The AXP-PLV requires 12 VDC power to operate properly. The Central Controller supplies power

via the AXlink cable or external auxiliary 12 VDC power supply. The maximum wiring distance

between the Central Controller and AXP-PLV is determined by power consumption, supplied

voltage, and the wire gauge used for the cable. The Wiring Guidelines tablelists wire sizes and the

maximum lengths allowable between the camera centers and control system. The maximum wiring

lengths for using AXlink power are based on a minimum of 13.5 VDC available at the control

system’s power supply.

If you install the AXP-PLV farther away from the control system than recommended in the above

table, connect an external 12 VDC power supply to the camera controller according to the wiring

diagrams described in this section.

Device DIP Switch Settings

Position 12345678

On value 1248163264128

Wiring Guidelines

Wire size Maximum wiring length

18 AWG 217.35 feet (66.25 m)

20 AWG 137.51 feet (41.92 m)

22 AWG 85.73 feet (26.13 m)

24 AWG 54.042 feet (16.47 m)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Brak uwag

AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Instrukcja Obsługi Strona 10